Instruction Manual

8.13 BACK-UP UNIT
If the Transmitting Unit cannot be used, it can be replaced with a Transmitting Unit called
"BACK-UPUNIT";youneedtoaskforittoAutec.
ItisidenticaltotheUnitthatcannolongerbeused;theonlydi󰘯erenceisthepresenceof
theplate“BACK-UPUNIT”ontheTransmittingUnit.
Insert in the "BACK-UP UNIT" the “ID internal tx memory” of the Transmitting
Unit that cannot be used any longer and perform the address storage
procedure described below.
As required by standard IEC 60204-32, each Radio Remote Control is uniquely
identi󰄈ed through a serial number. Therefore, upon replacement of the Unit,
the serial number of the Transmitting Unit to be replaced must be marked
on the "BACK-UP UNIT", so that all Units belonging to the Radio Remote
Control will show the same serial number.
Autec cannot be held responsible if the serial number of the Transmitting
Unit to be replaced has not been marked on the "BACK-UP UNIT".
Address storage
With fully charged battery and "ID internal tx memory" in the "BACK-UP UNIT", perform this
procedure:
1. enabletheSTARTactuatorandkeepitenableduntilthegreenandredLEDsilluminate;
2. waituntilthegreenLEDblinksslowly;
3. within 3 seconds, activate in sequence the pushbuttons corresponding to PIN 1, PIN 2
and PIN 3 that compose the PIN code given in the Technical Data Sheet.
IfthePINcodeisincorrect,theredLEDilluminatesandtheTransmittingUnitswitcheso󰘯.
In this case, the storage procedure shall be repeated.
If the PIN code is correct, the green LED turns steady on and the Transmitting Unit switches
o󰘯:thisindicatesthattheaddresshasbeenstoredinthe"BACK-UPUNIT".Itisnow
possible to start the Radio Remote Control and control the Machine with the "BACK-UP
UNIT" Transmitting Unit.
AUTEC - AIR SERIES
General operating instructions 27
LIUSK4N01_eng-01