Instruction Manual

Signal Meaning
The green [B] and red [A] LEDs are
steady on during start up.
A wrong "ID internal tx memory" has been inserted in the
Transmitting Unit, or this is a "BACK-UP UNIT".
The green [B] and red [A] LEDs
blink 3 times per second during
start up.
"ID internal tx memory" is damaged.
The green LED [B] is lit with a
steady light and the red LED [A]
blinks two times per second during
start up.
The START actuator is activated.
The green [B] and red [A] LEDs
blink alternating.
30 s left before the Transmitting Unit automatically
switcheso󰘯.
The green LED [B] repeats the
sequence: 3 blinks and a pause,
and the red LED [A] is steady on
during start up.
The UNPAIR procedure has been carried out.
7.2 Green CHARGE LED [D] and red CHARGE LED [E]
The meaning of green CHARGE LED [D] and red CHARGE LED [E] signals is described
in the following table. They only illuminate when the Transmitting Unit is being recharged.
ThemeaningoftheredandgreenCHARGELEDsignalscannotbemodi󰘰ed.
Signal Meaning
The green CHARGE LED [D] is
steady on.
The Transmitting Unit is under charge and charging has
been completed.
The red CHARGE LED [E] is steady
on.
The Transmitting Unit is under charge and charging has
not been completed yet.
18
LIUSK4N01_eng-01
Light signals
AUTEC - AIR SERIES