Instruction Manual

9 Maintenance
9.1 Radio Remote Control maintenance - general directions
TheMaintenanceTechnicianmust:
- observe and comply with all instructions and warnings provided by the Machine
Manufacturer;
- observeandcomplywithallinstructionsandwarningsprovidedbytheInstaller;
- observe and comply with all instructions and warnings provided by the Person responsible
fortheMachinecommissioningormakingtheMachineavailableforwork;
- observe and comply with all instructions and warnings provided in the Radio Remote
ControlManual;
- observe and comply with all applicable Laws, Regulations and Standards, even local.
- operate the Autec Radio Remote Control only in accordance with this Manual and all
of its Parts, and with all Autec warnings and instructions, and with applicable Laws,
RegulationsandStandards,evenlocal;
- operate the Machine operated by or through the Autec Radio Remote Control only in
accordance with the Machine Manufacturer’s instructions and warnings, and with applicable
Laws,RegulationsandStandards,evenlocal;
- operate the Machine operated by or through the Autec Radio Remote Control only when
heisinasafeconditionandcanperfectlyseethewholeMachine'sworkingarea;
- immediately inform his supervisors and/or the people in charge for the working place
and/or for the Machine about any possible failure, damage, loosening, anomalous wear,
detachment and/or any other anomaly that may cause malfunction to the Radio Remote
Controland/ortotheMachine,orthatmaycausedamagetopeopleand/orproperty;
- keeptheTransmittingUnitsecureandoutofreachof unauthorizedandunquali󰘰ed
Personnel.
ADDITIONAL WARNINGS AND INSTRUCTIONS THAT ARE CONTAINED IN
THE OTHER PARTS OF THIS MANUAL MUST BE FOLLOWED.
All󰘰ne-tuning,checkingandmaintenanceactionscarriedoutontheRadioRemoteControl
shallbeveri󰘰edandrecordedbythePersoninchargeofcarryingoutmaintenanceonthe
Machine.
Before any maintenance operation, disconnect the Receiving Unit from the
power supply, using the devices and instructions provided by the Machine
Manufacturer and by the Installer.
After each maintenance operation, always make sure that all commands sent
by the Transmitting Unit activate only the corresponding expected operations.
AUTEC - AIR SERIES
Maintenance 43
LIUAIR003_eng-01