Instruction Manual

6.2 Sta󰓐 training: installation and maintenance
All installation and maintenance operations relating to the Autec Radio Remote Control system
mustbecarriedoutbyONLYquali󰘰edtechnicians.Withoutlimitationontheforegoing,such
techniciansmustbetrainedandquali󰘰edwithrespectto:
- theactivitytoperform;
- warnings resulting from the risk assessment, concerning the Radio Remote Control
installationand/ormaintenance;
- allapplicableLaws,RegulationsandStandards,evenlocal,includingalsosafetyrules;
- operations and requirements of the Machine on which the Radio Remote Control is to
beinstalled;
- instructions and warnings provided in the Manual and any other documents related to
theRadioRemoteControlandtotheradioremotecontrolledMachine;
- directions by the Machine Manufacturer and by the Person in charge for safety in the
workplace where the system "Machine + Radio Remote Control" is used.
General instructions for installation and maintenance are provided in chapter 6 and in chapter
9 respectively.
Instructionsforthedi󰘯erentUnitsaredescribedinthespeci󰘰cManual'spartsrelatedtothe
Units. Therefore, please refer to that parts of the Instruction Manual.
6.3 Classi󰄈cation of commands
Thisparagraphdescribestheclassi󰘰cationofcommandsintheRadioRemoteControl:such
information is useful during installation and maintenance.
6.3.1 Type of command: analogue or digital
Commands sent by the Transmitting Unit can either be analogue or digital.
Analogue commands generate proportional outputs as a function of the position of the
corresponding actuator.
Digital commands switch the status of their corresponding output, according to the position
oftherelatedactuator.Thisstatuscaneitherbeonoro󰘯.
6.3.2 Name of commands
AllcommandssentbytheTransmittingUnitareidenti󰘰edwithabbreviationssuchasS0,
S1, S2, S3, etc.
Those abbreviations are provided in the Technical Data Sheet that must be used when
installingthesystem,andinparticular:
- inthedrawingoftheTransmittingUnit,wherecommandsandtheirlayoutareindicated;
- in the wiring diagram of the Receiving Unit.
This is helpful to highlight the relation between the commands sent by the Transmitting Unit
and those available on the Receiving Unit.
26
LIUAIR003_eng-01
Installation
AUTEC - AIR SERIES