User's Manual

AUTEC - Air series
General operating instructions 27
LIUSK4N00_eng-00
8.13 BACK-UP UNIT
If the Transmitting Unit cannot be used, it can be replaced with a Transmitting Unit called
"BACK-UP UNIT"; you need to ask for it to Autec.
It is identical to the Unit that cannot be used any more; the only di󰘯erence is the presence
of the plate “BACK-UP UNIT” on the Transmitting Unit.
Insert in the "BACK-UP UNIT" the “ID internal tx memory” of the Transmitting
Unit that cannot be used any longer and perform the address storage
procedure described below.
Address storage
With fully charged battery and "ID internal tx memory" in the "BACK-UP UNIT", perform this
procedure:
1. enable the START actuator and keep it enabled until the green and red LEDs illuminate;
2. wait until the green LED blinks slowly;
3. within 3 seconds, activate in sequence the pushbuttons corresponding to PIN 1, PIN 2
and PIN 3 that compose the PIN code given in the Technical Data Sheet.
If the PIN code is incorrect, the red LED illuminates and the Transmitting Unit switches o󰘯.
In this case, the storage procedure shall be repeated.
If the PIN code is correct, the green LED turns steady on and the Transmitting Unit switches
o󰘯: this indicates that the address has been stored in the "BACK-UP UNIT". It is now
possible to start the Radio Remote Control and control the Machine with the "BACK-UP
UNIT" Transmitting Unit.