User's Manual

AUTEC - Air series
General operating instructions 21
LIUSK4N00_eng-00
8.5 Starting up the Radio Remote Control
Starting up the Radio Remote Control consists in establishing a radio link between the
Transmitting Unit and the Receiving Unit.
The Radio Remote Control start up is protected by a PIN code to prevent
unauthorised use of the Machine.
To activate the Radio Remote Control, enter the PIN code following the
procedure described in paragraph 8.5.1.
The PIN code is not a sequence of numbers, but it consists in the sequential activation of
actuators.
Commands associated to the actuators that are activated while inserting the PIN
code are not sent to the Machine.
8.5.1 Start up through PIN code
When the Receiving Unit is correctly powered on, perform the following procedure; activate
each actuator within 3 seconds after releasing the previous one:
1. enable START and keep it enabled until the green LED illuminates;
2. activate the commands corresponding to PIN code in the correct sequence (PIN 1, PIN
2 and PIN 3 given in the Technical Data Sheet).
a. PIN 1 shall not be included in the start up procedure if it corresponds with START.
b. PIN 3 shall not be included in the start up procedure if it corresponds with START.
3. enable START and keep it enabled until the green LED blinks fast,
4. release START.
When the green LED blinks slowly, the Radio Remote Control is active and it can send
commands and activate the Machine.
Note: default PIN code set by AUTEC is:
- PIN 1=START.
- PIN 2=S0 (see Technical Data Sheet).
- PIN 3=START.
Autec will set a customized PIN code only upon request by the Machine
Manufacturer or the Installer.