User's Manual
AUTEC - Air series
General operating instructions 19
LIUSK4N00_eng-00
8 General operating instructions
8.1 START pushbutton/selector
The START pushbutton/selector is used to:
- start the Radio Remote Control (see paragraph 8.5),
- activate the horn when the Radio Remote Control is started.
8.2 STOP pushbutton
When the STOP pushbutton is activated, the Machine stops and the Transmitting Unit switches
o. To start the Radio Remote Control again and enable it to control the Machine after the
STOP pushbutton has been pressed, you need to:
- make sure that the working and usage conditions are safe,
- pull or turn the STOP pushbutton in the arrow direction to unlock it,
- start the Radio Remote Control following the procedure described in paragraph 8.5.
The STOP pushbutton should be pressed when it is necessary to stop the
Machine immediately whenever a dangerous condition occurs.
The Machine Manufacturer and/or the Installer must provide the instructions
and warnings concerning possible risks that may originate from the Machine
stop (by way of example: inertial movements, swinging load…).
8.3 Recharging the SK4 Transmitting Unit's battery
The SK4 Transmitting Unit contains a rechargeable battery (AIRBM3V7L); the provided
battery is already partially charged.
To recharge the SK4 Unit you must only use the cable supplied by Autec: connect it to a
power supply source providing the values given in the technical data that are indicated in
"Part E" of the Manual.
To use the SK4 Unit and its battery correctly, "Part E" of the Manual shall be fully understood
and kept into account; this part specically refers to the recharging device and to the battery,
and it contains instruction for their use, storage and maintenance.