User's Manual

2
LIRNFE00-01
Description
AUTEC - Air series
1 Description
The receiving unit uses the CANopen® communication protocol to communicate in a CAN
bus network. The receiving unit acts as a slave node within this network.
This way, the STOP and SAFETY commands sent by the transmitting unit activate their
corresponding outputs and are also sent via CAN network.
It is not possible to only rely on the CAN communication status to maintain
or bring the remote controlled machine to a safe condition. Messages sent
by the radio remote control via CAN network do not in fact ensure the same
safety features as the corresponding commands that are directly carried
out by the receiving unit's safety outputs.
SERIAL N. XXXXXX
MANIF. DATE XXXX
A
B
E
F
G
H
J
C
K L
M
N
P
D
A BNC connector for antenna
B Power supply protection fuse
C
SAFETY contact protection
fuse
D DIP switches
E Connector for cable control
F ERR LED
G RUN LED
H ENABLE LED
J POWER LED
K Technical data plate
L Identi󰘰cation plate
M
Electronic module and address
key
N STOP contacts protection fuses
P Plug or cable gland