User's Manual
6.4 Command outputs
The data sheet contains information regarding the correspondence between the commands
sent by the transmitting unit and the related output enabled in the receiving unit.
7 Malfunction signalled by the receiving unit
Use the light signals on the receiving unit to identify the radio remote control malfunction.
If the problem persists after the suggested solution has been carried out, contact the support
service of the machine manufacturer.
LEDs
Signals Possible reason Solutions
POWER
Switched off
The connecting plug between
the radio remote control and
the machine is not connected
correctly.
Correctly plug in the
connecting plug.
Fuse F1 is damaged. Replace the fuse.
Wrong or no power supply.
Make sure that power supply
wires are correctly connected
and that the power supply
value is within the limits
speciîżed in the technical data.
On Receiving unit powered on.
Make sure that the outputs
are correctly wired and that
the power supply is within the
limits provided the technical
data.
Start up the radio remote
control.
ENABLE
Blinks once
every 5 seconds
The transmitting and receiving
unit do not communicate.
Start up the radio remote
control.
Blinks fast
Radio remote control is
started up: the unit is ready to
receive commands from the
transmitting unit.
Make sure that commands
sent enable the corresponding
relays and that the relays go
back to the rest position when
the command is released.
AUTEC - AIR SERIES
Malfunction signalled by the receiving unit 5
LIRMCE00-00