User's Manual

Group the wiring away from the electronic module, in order to avoid
interferences and hazards related to electrical safety.
Evaluate the radio remote control's wiring and remember that if the output
dedicated to the machine's horn, siren or blinker is used for another command
due to application's and/or functional reasons, some procedures in the
“Con󰄈gurationMenu”mayresultunavailablelateron.
To wire the terminals corresponding to the commands' outputs, to the STOP
outputs and to the SAFETY outputs, it is recommended to use a 3.5x0.4mm slot
screwdriver (e.g. WAGO code 210-720).
3.5 At end of installation
Make sure that during installation the safety mechanisms on the radio remote
controland/orinthemachinehavenotbeenmadeine󰓐ectivebypossible
procedures carried out.
Look up in the technical data sheet and check that the frequency band set
in the radio remote control is permitted in the Country of use.
Correctly close the receiving unit so that the protection degree from dust
and water is not jeopardised: check that the gasket is intact, correctly put
the housing parts one over the other so that they overlap, and screw in the
screws.
12
LIAIRE00-02
Warnings for installation
AUTEC - AIR SERIES