User's Manual

Table Of Contents

AUTEC - AIR series

38 A8 transmitting unit

Recharging the A8 unit

4.4 Recharging the A8 unit

The A8 unit contains a rechargeable battery; the provided battery is partially charged.

To correctly use the A8 unit and its battery, the related chapter shall be fully understood and

kept into account.

First power on the docking station with its power supply unit and then:

1) insert the A8 unit into the docking station: a steady on red

LED indicates that charging has started (max. 4 h)

2) remove the A8 unit from the docking station when necessary

Note: when the green LED switches on, the A8 unit is complete-

ly charged.

Charge the unit at a temperature between 5°C and 45°C.

Indication of A8 unit run time

Perform the following procedure to check the transmitting unit's run time:

1) switch off the transmitting unit and unlock the STOP pushbutton

2) keep pushbuttons S1 and START pressed until the 3 left LEDs illuminate

showing the unit's run time (3 illuminated LEDs correspond to the highest

run time).

Run time indication disappears after some seconds.

4.5 Docking station AIRDOCK01

The docking station AIRDOCK01 is used to recharge the A8 unit.

Plug in the adapter in the socket on the back of the docking station.

The adapter works with 100 - 240 V (optional 10 - 30 V ).

To correctly use the docking station and its power supply unit, respect

the indications given in the related chapter.

STARTFUNCT.

STOP

S1 S2

START

MAX. MIN.