User's Manual

AUTEC - AIR series
34 A8 transmitting unit
Description of the A8 unit
4 A8 transmitting unit
4.1 Description of the A8 unit
4.2 Operation
4.2.1 Start up with PIN code
As required by standard IEC 60204-32, the radio remote control start up is pro-
tected by a PIN code, in order to prevent non authorised use of the machine.
During the start up phase, press each pushbutton within 3 seconds from the release of the
previous pushbutton, or the transmitting unit will switch off.
Start up through factory-set PIN
When the receiving unit is powered on, perform the following procedure:
1) press the START pushbutton until the green LED illuminates
2) press the FUNCTION pushbutton
3) press the START pushbutton until the green LED blinks slowly.
LEDs
STOP pushbutton
Command pushbuttons
Technical data plate
Identification plate
START
pushbutton
FUNCTION
pushbutton
Contacts for recharge
Screw and battery cover
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2
1) START 2) FUNCTION 3) START
STARTFUNCT.
1
2
34
R
G
STOP
S1 S2