User's Manual
Table Of Contents
- Copertina esterna fronte LIMM&SA0-00.pdf
- Copertina interna fronte LIMM&SA0-00.pdf
- LIMM&SA0-00.pdf
- 1 Introduction
- 2 Transmitting units
- 3 Receiving unit
- 3.1 Description of the receiving unit
- 3.2 Inner parts of the “Master/Slave” receiving units
- 3.3 Inner parts of the “Master/Master” receiving units
- 3.4 General warnings for the installation of the receiving unit
- 3.5 Specific warnings for the installation of the receiving unit
- 3.6 Warnings for the maintenance of the receiving unit
- 3.7 External signal lights of the receiving unit
- 3.8 Internal signal lights of the receiving unit
- 4 Operating mode of “Master/Slave”
- 5 Operating mode of “Master/Master”
- 6 Operating mode of the transmitting units
- 7 Maintenance
- 8 Programming
- 9 Diagnostics
- bianca A4.pdf
- Copertina esterna retro LIMM&SA0-00.pdf
6 Operating mode of the transmitting units
- 21 -
LIMM&SA0-00.fm
6 OPERATING MODE OF THE TRANSMITTING UNITS
COMMAND
ACTIVATION
SIGNALS
COMMAND
ACTIVATION
SIGNALS
SWITCHING OFF
STOP
BATTERY
SWITCHING OFF
STOP
BATTERY
6.1 Command activation
Activate the joysticks, pushbuttons and/or selectors related to any of the movement or selection
commands to be carried out.
Selector
1/1+2/2 in a
Master/Slave
The transmitting unit UTX-M has a selector 1/1+2/2 to select the working position:
- position 1 (single mode): the transmitting unit UTX-M works with the receiving unit URX-1
- position 1+2 (tandem mode): the transmitting unit UTX-M works both with the receiving unit
URX-1 and the receiving unit URX-2 (in this case the transmitting unit UTX-M must previously
engage the receiving unit URX-2: see paragraph 4.1)
- position 2 (single mode): the transmitting unit UTX-M works with the receiving unit URX-2 (in
this case the transmitting unit UTX-M must previously engage the receiving unit URX-2: see
paragraph 4.1)
Selector
1/1+2/2 in a
Master/Master
The transmitting units UTX-M and UTX-S have a selector 1/1+2/2 to select the working position:
- position 1 (single mode): the transmitting unit works with the receiving unit URX-1
- position 1+2 (tandem mode): the transmitting unit works both with the receiving unit URX-1
and with the receiving unit URX-2
- position 2 (single mode): the transmitting unit works with the receiving unit URX-2
Selection of the desired position with the toggle switch is only possible after the transmitting
unit has engaged the receiving unit/s needed for working (see paragraph 5.1).