User's Manual
Table Of Contents
Page 4 2 - Introduction LI14CAA0-00 - AmEn.fm
Technical data sheet
The technical data sheet shows the wiring diagram between the receiving unit and the ma-
chine. The technical data sheet must be filled in and checked by the installer, who is re-
sponsible for a correct wiring. Once all necessary checks have been carried out, the
installer must undersign the technical data sheet, which must be kept with the user's man
-
ual (always keep a copy of this data sheet for administrative purposes).
Identification plates
The radio remote control identification and approval data is given on plates that are on both
the transmitting unit and the receiving unit.
These plates MUST NOT be:
- removed from their position
- altered or damaged (contact Autec or an authorized representative for replacement)
2.3 GENERAL TECHNICAL DATA
Due to the characteristics of radio propagation (i.e.: EM interferences, near
out-of-range condition), a delay up to one second may occasionally occur be-
tween command release and actual deactivation of the corresponding output.
Care must be taken to ensure that this could never lead to a dangerous situa-
tion in the specific uses.
Frequency band ...................................................................................... 902 -928 MHz
Available radio channels ........................................................................................... 32
Hamming distance .................................................................................................... ≥ 8
Probability of undetected error..................................................................... <10 exp-11
Typical working range............................................................................. 330 ft (100 m)
Command response time................................................................................ ~ 100 ms
STOP command response time.......................................................................~ 100 ms
Passive emergency time (or passive stop)
*
................................................ 0.35/1 sec.
*refer to paragraph 7.1 "Programming the E16SRXUS1 radio receiving module" DIP nr. 1 settings.