User's Manual

LI14CAA0-00 - AmEn.fm 7 - Programming Page 11
7 PROGRAMMING
The dip switches must be programmed when the receiving unit is not powered.
Programming must only be carried out by authorized personnel.
For the correct functioning, the group of 8 dip switches (excluding DIP 1) for
the radio modules E16STXUS1 (transmitting unit) and E16SRXUS1 (receiving
unit) must be set in the same way.
The incorrect closure of the receiving unit can compromise the seal between
the casings and thereby the protection degree from dust and water.
7.1 PROGRAMMING THE E16SRXUS1 RADIO RECEIVING MODULE
Group of 8
dip switches
Group of 4 dip
switches
The group of eight dip switches locat-
ed on the radio module are used to
program some functions and set the
working frequency.
The programming set in the other
group of four dip switches must never
be modified.
Group of 8 dip switches
DIP STATE FUNCTION
1
ON
Stop after 0.35 sec with invalid radio signal
OFF
Stop after 1 sec with invalid radio signal
2
ON
Deactivation of low battery warning from horn on
machine
OFF
Activation of low battery warning from horn on machine
3
ON
If DIP 8 is OFF automatic scan of the frequencies in the
band 915 - 928 MHz
OFF
If DIP 8 is OFF automatic scan of the frequencies in the
band 902 - 915 MHz
3-7 ON/OFF
If DIP 8 is ON see “Appendix: Frequency Table”
8
ON
Manual selection mode of the frequencies using DIP 3 -
DIP 7 (refer to “Appendix: Frequency Table”)
OFF
Automatic scan mode of the frequencies in the band
selected by DIP 3 (DIP 4 - DIP 7 indifferent)