User's Manual
Table Of Contents
WARNINGS FOR INSTALLATION
4
!
PLACE the receiving unit vertically, with the cable holder (or plug)
facing down.
FIX the receiving unit at least in four points, using the specific holes
located in the housing.
If installing on machines that vibrate, FIX the receiving unit to the
machine with the appropriate antivibration absorbers.
DO NOT MODIFY or TAMPER WITH the radio remote control, the
machine or its electric panel. DO NOT PERFORATE the receiving unit for
any reason whatsoever.
CHECK that the receiving unit power supply is inside the voltage range
given in the “Technical Data”, and that the voltages and currents being
used do not exceed the maximum permitted values.
DO NOT EXCLUDE the radio remote control safety mechanisms and/or
those present inside the machine.
RESPECT all the machines and for hoisting machines
(see corresponding IEC ).
NEVER SUPPLY the receiving unit directly from the mains. A main
switch should always be present to permit power supply removal.
PLACE the receiving unit so that it is not completely screened by metal
parts and that it must be easily reachable.
REMEMBER to carefully wire the SAFETY contacts in series with the
movement commands inside the receiving unit.
After installation and wiring, ALWAYS CHECK that the maneuvers
carried out are exactly the same as the commands given (in particular
check the STOP command).
prescriptions for
60204-1 and IEC60204-32 prescriptions
LIE&LAA0
Installation should only be carried out by qualified people and in
accordance with installation country rules.
Page 8
THE INSTALLER
MUST
FAILURE TO COMPLY WITH THE ABOVE WARNINGS MAY RESULT IN
SERIOUS INJURY OR DEATH TO PERSONNEL AND DAMAGE TO
EQUIPMENT.