User's Manual

LIGHT SIGNALS
8
Each receiving unit has lights that indicate
the state of the receiving unit and its relays.
On the internal receiver module there are three LEDs, which indicate:
1. power supply
2. radio connection
3. frequency scanning.
POWER: indicates that the receiving unit is powered
STOP/ENABLE: indicates that the radio link from the transmitter is active.
SAFETY: indicates that the SAFETY function has been activated (this function should
activate with any movement commands)
START/ : indicates activation of the START pushbutton or the horn
RL _: indicates that the relay of the corresponding command has been activated (see
radio remote control technical data sheet)
Page 14
STOP/ENA
POWER
START/
SAFETY
RL 1 RL 2 RL 3 RL 4 RL 5 RL 6 RL 7 RL 8 RL 9
RL 10
RL 11
RL 12 RL 13 RL 14
LIE&LQA0
1 2 3