User's Manual

Page 8
LIE&LQA0
The presence of vibrations can compromise receiving unit performance: it is therefore
advisable to use suitable rubber mountings.
Antenna assembly is covered in the installation instructions (refer to chapter 7 for
details and warnings).
The installer must CHECK and/or COMPLETE the "Technical Data Sheet" indicating the
date of activation of the system, putting his signature and stamp.
!
SUPPLY THE RECEIVING UNIT BY A SAFETY ISOLATING
TRANSFORMER.
The source of POWER SUPPLY must be protected from short circuit.
WHEN WELDING ON THE MACHINE during installation or use, remove
all electrical connections including the aerial from the receiver unit.
WHEN WIRING, all relevant standards and regulations must be
complied with.