User's Manual

ManualsBrandsAutec ManualsElectronicsTransceiver unit

Original instructions

DYNAMIC SERIES

Receiving unit PCR

INDEX

1 Description ............................................................................................................ 2

2 Technical data ....................................................................................................... 3

3 Technical data sheet ............................................................................................. 3

4 Plates ..................................................................................................................... 4

5 Light signals .......................................................................................................... 4

5.1 POWER LED (green) ....................................................................................... 4

5.2 ALARM LED (red) ............................................................................................ 5

5.3 STATUS LED (blue) ......................................................................................... 5

5.4 LED RUN (green) e LED ERR (red) ................................................................. 5

5.5 SETUP LED (yellow) ........................................................................................ 5

6 Malfunction signalled by the receiving unit ........................................................ 6

AUTEC LIPCRE00-00

Summary of content (8 pages)

PAGE 1
Original instructions Dynamic Series Receiving unit PCR Index 1 2 3 4 5 Description ............................................................................................................. Technical data ........................................................................................................ Technical data sheet .............................................................................................. Plates ........................................................................
PAGE 2
1 Description Description A plugs B mounting holes C Antenna D LED E Technical data plate F Radio remote control identification plate The receiving unit is interfaced with the machine through the outputs and their wiring and/or through a CAN network (of which it is a master node). The STOP (STP_1 and STP_2) and SAFETY (SAF_1 and SAF_2) outputs are some of the receiving unit's outputs.
PAGE 3
Technical data 2 3 Technical data Power supply ......................................................................................................... 8-30V Antenna ............................................................................................................... dedicated Rated current of STP_1 and STP_2 outputs ..................................................... 2A (30V ) Rated current of the SAF_1 output ...................................................................
PAGE 4
4 Plates Plates The receiving unit has the following plates: Plate radio remote control identification plate technical data plate 5 Position Content On the casing of the receiving unit Radio remote control serial number (S/N), bar code and manufacturing year. On the casing of the receiving unit MODEL, TYPE and main receiving unit technical data, marking and possible radio remote control marks.
PAGE 5
Plates 5 5.2 ALARM LED (red) The ALARM LED warns about anomalies in the receiving unit. The ALARM LED... …is off The receiving unit works correctly. ... blinks once Error on the STOP outputs. ... blinks twice Error on the SAFETY outputs. ... blinks three times ... is on 5.3 Meaning Error on the outputs corresponding to direction commands. The receiving unit does not work correctly.
PAGE 6
Malfunction signalled by the receiving unit 6 Malfunction signalled by the receiving unit Use the light signals on the receiving unit to identify the radio remote control malfunction. If the problem persists after the suggested solution has been carried out, contact the support service of the machine manufacturer. Signals Possible reason Solutions The POWER LED is off. The receiving unit is not powered.
PAGE 7
Malfunction signalled by the receiving unit Signals 7 Possible reason Solutions The STATUS LED blinks slowly. Over-voltage on power supply. Make sure that the receiving unit power supply is within the voltage limits provided in the technical data. The STATUS LED blinks fast and irregularly. The receiving unit loses some data sent by the transmitting unit. Bring the transmitting unit closer to the receiving unit. If this signal persists, contact the support service of the machine manufacturer.
PAGE 8