User's Manual

AUTEC - Air series
Light signals 5
LILK6E00-01
5 Light signals
In LK6 and LK8 transmitting units, a green LED [B] and a red LED [A] are always available,
and they provide information regarding the radio remote control.
A Red LED
B Green LED
C
LEDs for Data
Feedback function
The green LED [B] … Meaning
…is o󰓐. Thetransmittingunitisswitchedo󰘯.
... is steady on. The transmitting and receiving unit do not communicate.
… blinks fast.
The transmitting and receiving unit communicate. It is only
possible to send commands after pressing the START
pushbutton.
… blinks slowly (one blink per
second).
It is possible to send commands.
The red LED [A]… Meaning
…is o󰓐. The transmitting unit works correctly.
... is steady on. At start-up, the STOP pushbutton is pressed or damaged.
... blinks twice per second.
At least one of the commands that were checked at start-
up is enabled or damaged (see technical data sheet).
... blinks three times per second. Atstart-up,thebatteryis󰘱at.
... is steady on for 2s. The transmitting unit does not work correctly.
… blinks slowly (one blink per
second).
The battery has less than 1h run time.
... blinks fast. The battery has a 10min run time.