User's Manual

AUTEC - Air series
Operation 11
LILK6E00-01
7.1.2 Battery removal
Push the battery towards the contacts on the transmitting unit and remove it from the housing.
7.1.3 Battery run time indicator
Perform the following procedure to check the run time of the battery in the transmitting unit:
1. switcho󰘯thetransmittingunitandunlocktheSTOPpushbutton
2. activate command S1 (check in the technical data sheet which actuator it corresponds
to) and press the START pushbutton until LED 1, LED 2 and LED 3 (indicating battery
level) illuminate:
- 1 LED on: low level
- 2 LEDs on: medium level
- 3 LEDs on: maximum level.
Run time indication disappears after some seconds.
7.2 ID internal tx memory
Thetransmittingunitmayrequirethe"IDinternaltxmemory",wheretheradioremotecontrol's
address is stored.The technical data sheet indicates if the "ID internal tx memory" is required.
7.3 Power keyswitch
The transmitting unit may have a power keyswitch. It can either be:
- mechanical key (see paragraph 7.3.1)
- Key ID 0-1 (see paragraph 7.3.2).
7.3.1 Mechanical key
The mechanical key makes it possible to power the transmitting unit. When the mechanical
key is required to be used in a transmitting unit, the radio remote control cannot work if it
is not inserted.
7.3.2 Key ID 0-1
The "Key ID 0-1" makes it possible to power the transmitting unit.
Itstorestheradioremotecontrol'saddress.Therefore,the"KeyID0-1"canonlybeused
in the transmitting unit belonging to its related radio remote control: when the transmitting
unit requires the "Key ID 0-1", the radio remote control cannot work if it is not inserted. The
technical data sheet indicates if the "Key ID 0-1" is required.
As the radio remote control address is stored in the "Key ID 0-1", use it with utmost care to
reduce risks that may result from incorrect handling.
7.3.3 power keyswitch insertion
Perform the following operations to insert the power keyswitch:
1. push the power keyswitch inside the corresponding housing
2. rotate the power keyswitch clockwise.
7.3.4 power keyswitch removal
Perform the following operations to remove the power keyswitch:
3. rotate the power keyswitch anticlockwise
4. pull the power keyswitch to remove it from the corresponding housing.