User's Manual

10
LILK6E00-01
Operation
AUTEC - Air series
6.5.1 Low battery
Thetransmittingunitindicatesifthebatteryisnotsu󰘲cientlycharged(theredLEDblinksfast):
- the red LED blinks slowly (one blink per second): the battery has less than 1h run time.
- theredLEDblinksfast:thebatteryhasa10minuteruntimefromthe󰘰rstsignal,after
whichthetransmittingunitautomaticallyswitcheso󰘯.
The battery needs to be replaced with a charged one (see paragraph 7.1).
6.5.2 When the transmitting unit is not used
If the transmitting units remains started with no enabled commands, it will automatically
switcho󰘯afterapredeterminedtimeframe.Thistimeframeisspeci󰘰edinthetechnicaldata
sheet (SWITCH-OFF).
Beforethetransmittingunitswitcheso󰘯automatically,thegreenandredLEDsblinkalternating
for 30 seconds.
Activating any actuator corresponding to a movement command reduces the predetermined
automaticswitch-o󰘯time(SWITCH-OFF)tozero.
6.6 Switching o󰓐 the transmitting unit
The transmitting unit shall be switched o󰓐 each time work is stopped
Voluntarytransmittingunit'sswitcho󰘯occurs:
- when the power keyswitch (if present) is turned anti-clockwise
- when battery is removed (see paragraph 7.1.2)
- when the STOP pushbutton is pressed.
7 Operation
7.1 Battery
The Air series' transmitting units can only be powered by Autec rechargeable
batteries.
See the battery charger manual enclosed in the packaging with the battery
charger for any warnings and instructions regarding the batteries.
7.1.1 Battery insertion
Push the battery towards the contacts on the transmitting unit and insert it inside the housing.