User's Manual

AUTEC - Air series
Operation 21
LILK1E00-01
7.8 Pushbuttons on the back of the transmitting unit
Up to two pushbuttons can be provided on the back of the transmitting unit.
In the LK NEO 10 DF, one of these two pushbuttons is the DISPLAY pushbutton (see
paragraph 7.7).
These pushbuttons protrude from the transmitting unit housing; therefore they are not protected
from accidental activation, due for example to dropping the unit.
For this reason, they are only provided in the transmitting unit upon request of the manufacturer
of the remote controlled machine and/or of the installer of the radio remote control on the
machine.
Pushbuttons on the back of the transmitting unit cannot be used to send
to the machine commands that may generate dangerous situations if
unintentionally activated. For example, it is possible to use them to activate
the machine's lamp and/or horn.
This must be taken into account in the risk assessment of the "machine +
radio remote control" system.
The machine's manufacturer and/or the installer of the radio remote control
on the machine have the responsibility to decide which commands are
matched with these pushbuttons.
7.9 Vibration alarm
The LK NEO 10 DF transmitting unit can be equipped with the Vibration alarm.
TheVibrationalarmactivatesthetransmittingunit'svibrationifspeci󰘰csignalscomingfrom
the "machine + radio remote control" system are shown on the display.
Thetransmittingunit'svibrationaimsatdrawingtheuser'sattentiontothecorresponding
signal shown on the display.
The Vibration alarm is only provided in the transmitting unit upon request of the manufacturer
of the remote controlled machine and/or of the installer of the radio remote control on the
machine.
The machine's manufacturer and/or the installer of the radio remote control
on the machine decide which signals shown in the display must cause the
vibration of the transmitting unit.