User's Manual

14
LILK1E00-01
General operating instructions
AUTEC - Air series
6.1.2 PIN CODE start up (no power keyswitch)
Considerthatthetransmittingunitwillswitcho󰘯3secondsafterlastactivation
of an actuator.
When the receiving unit is powered on, perform the following procedure:
1. Insert a charged battery in the transmitting unit (see paragraph 7.1.1)
2. press the START pushbutton until the green LED illuminates
3. activate the commands corresponding to PIN CODE in the correct sequence (PIN 1, PIN
2 and PIN 3 given in the technical data sheet).
a. PIN 1 shall not be included in the start up procedure if it coincides with the START
command.
b. PIN 3 shall not be included in the start up procedure if it coincides with the START
command.
4. press the START pushbutton until the green LED blinks slowly.
Note: default PIN CODE set by AUTEC is:
- PIN 1=START pushbutton
- PIN 2=FUNCTION pushbutton
- PIN 3=START pushbutton.
CustomPINCODEissetbyAutecuponrequestbythemachine'smanufacturerorbythose
who decided to install the radio remote control.
6.1.3 Power keyswitch and PIN CODE start up
When the receiving unit is powered on, perform the following procedure:
1. Insert a charged battery in the transmitting unit (see paragraph 7.1.1)
2. insert the power keyswitch in the transmitting unit (see paragraph 7.3.3).
Considerthatthetransmittingunitwillswitcho󰘯3secondsafterlastactivation
of an actuator.
3. press the START pushbutton until the green LED illuminates
4. activate the commands corresponding to PIN CODE in the correct sequence (PIN 1, PIN
2 and PIN 3 given in the technical data sheet).
a. PIN 1 shall not be included in the start up procedure if it coincides with the START
command.
b. PIN 3 shall not be included in the start up procedure if it coincides with the START
command.
5. press the START pushbutton until the green LED blinks slowly.