Instruction Manual

8.7.3 Indication of the battery charge level in the LK NEO 6 DF Transmitting Unit
(Model LKN Type DA1DM)
See paragraph 7.2.2 to check the battery charge level in the LK NEO 6 DF Transmitting Unit.
8.7.4 Indication of the battery charge level in the LK NEO 6 and LK NEO 8 Transmitting
Unit (Model LKN Type LA1CM)
Perform the following procedure to check the charge level of the battery in the LK NEO 6
and LK NEO 8 Transmitting Units:
1. switch o󰘯 the Transmitting Unit and unlock the STOP pushbutton,
2. press the "Enabling&Stop" pushbutton halfway (ON - 󰘰rst step, see paragraph 8.6);
3. activate command S1 (check in the Technical Data Sheet which actuator it corresponds
to) and press the START pushbutton until LED 1, LED 2 and LED 3 (indicating battery
level) illuminate:
- 1 LED on: low level
- 2 LEDs on: medium level.
- 3 LEDs on: maximum level.
Run time indication disappears after some seconds.
Commands associated to the actuators that are activated during the procedure
to check the battery charge level are not sent to the Machine.
32
LIULK6ES0_eng-01
General operating instructions
AUTEC - Air series