User's Manual
AUTEC - Air series
Operation 17
LILK6E00-02
7 Operation
7.1 Battery
The Air series' transmitting units can only be powered by Autec rechargeable
batteries.
See the battery charger manual enclosed in the packaging with the battery
charger for any warnings and instructions regarding the batteries.
7.1.1 Battery insertion
Push the battery towards the contacts on the transmitting unit and insert it inside the housing.
7.1.2 Battery removal
Push the battery towards the contacts on the transmitting unit and remove it from the housing.
7.1.3 Battery run time indicator
LK6 and LK8 transmitting units
Perform the following procedure to check the run time of the battery in the LK6 and LK8
transmitting units:
1. switchothetransmittingunitandunlocktheSTOPpushbutton
2. activate command S1 (check in the technical data sheet which actuator it corresponds
to) and press the START pushbutton until LED 1, LED 2 and LED 3 (indicating battery
level) illuminate:
- 1 LED on: low level
- 2 LEDs on: medium level
- 3 LEDs on: maximum level.
Run time indication disappears after some seconds.
LK6 DF transmitting unit
See paragraph 5.2.2 to check the run time of the battery in the LK6 DF transmitting unit.