User's Manual

16
LILK6E00-02
General operating instructions
AUTEC - Air series
6.4 Radio link interruption
When the radio link is incorrect or interrupted, the receiving unit autonomously stops the
radio remote control.
The green LED on the transmitting unit switches from blinking slowly to fast blinking or
steady on.
Press the START pushbutton to start the radio remote control.
6.5 Transmitting unit automatic switch o󰓐
Thetransmittingunitautomaticallyswitcheso󰘯when:
- thebatteryis󰘱at(seeparagraph6.5.1)
- the radio remote control is not used for a certain time (see paragraph 6.5.2)
Press the START pushbutton to start the radio remote control.
6.5.1 Low battery
Thetransmittingunitindicatesifthebatteryisnotsu󰘲cientlycharged(theredLEDblinksfast):
- the red LED blinks slowly (one blink per second): the battery has less than 1h run time.
- theredLEDblinksfast:thebatteryhasa10minuteruntimefromthe󰘰rstsignal,after
whichthetransmittingunitautomaticallyswitcheso󰘯.
The battery needs to be replaced with a charged one (see paragraph 7.1).
6.5.2 When the transmitting unit is not used
If the transmitting units remains started with no enabled commands, it will automatically
switcho󰘯afterapredeterminedtimeframe.Thistimeframeisspeci󰘰edinthetechnicaldata
sheet (SWITCH-OFF).
Beforethetransmittingunitswitcheso󰘯automatically,thegreenandredLEDsblinkalternating
for 30 seconds.
Activating any actuator corresponding to a movement command reduces the predetermined
automaticswitch-o󰘯time(SWITCH-OFF)tozero.
6.6 Switching o󰓐 the transmitting unit
The transmitting unit shall be switched o󰓐 each time work is stopped.
Voluntarytransmittingunit'sswitcho󰘯occurs:
- when the power keyswitch (if present) is turned anti-clockwise
- when battery is removed (see paragraph 7.1.2)
- when the STOP pushbutton is pressed.