Instruction Manual
LIUPJMV03_eng-00 AUTEC
30
8.14 Switching o the Transmitting Unit
Switch off the Transmitting Unit when not actively using the Radio Remote
Control to operate the Machine, or when work is otherwise interrupted, even
for short periods. Do not leave the load hanging or the Machine in dangerous
conditions (even when charging the Unit or changing the battery).
FAILURE TO DO SO CAN RESULT IN SERIOUS BODILY INJURY OR DEATH
AND/OR PROPERTY DAMAGE.
Voluntary switch off of the Transmitting Unit occurs in the following cases.
- when the power keyswitch is turned anti-clockwise or removed.
- When the battery is removed (see paragraph 8.7.2).
8.15 Cable control
The cable control is used:
- in particular working conditions, eablished by the Machine Manufacturer
- when it is not possible to eablish a radio link between the Radio Remote Control Units,
- when working in environments where using radio frequencies is not allowed or is dangerous,
- when a fully charged battery is not available.
ATTENTION: The use of the cable control entails risk of electric shock when
working near overhead or underground power line's cables.
8.15.1 Description
The cable control connects the Transmitting Unit to the Receiving Unit through a cable that
replaces the radio link. The cable shall be plugged in the suitable connectors, one on the
Transmitting Unit and the other on the Receiving Unit (or placed where eablished by the
Machine Manufacturer).
When using the cable control, the working features of the Radio Remote Control and of the
Take & Release Radio Remote Control (e.g. the meaning of actuators and the Data Feedback
function) do not change.