Instruction Manual

LIUPJMV03_eng-00AUTEC
29
The battery run time signalled by the Transmitting Unit is reduced by the following
factors:
- Battery ageing
- Increasing number of battery charge-discharge cycles
- Battery usage outside the range provided in paragraph "Operational usage" in
"Part A" of the Manual.
- Battery 󰘵orage in disregard of the indications given in paragraph "Storage" in the
in󰘵ruction manual for the use and maintenance of the battery and battery charger.
8.13.2 When the Transmitting Unit is not used
If the Transmitting Unit remains 󰘵arted for a certain time while none of these commands are
enabled: SAFETY, D2-D10, H1-H8 or L1-L8, then it automatically switches off. This time frame
is specified in the Technical Data Sheet (Automatic Switch Off).
Setting or removal of the automatic switch off time (Automatic Switch Off) is done
by Autec and decided by the Machine Manufacturer, according to his risk assessment
and to the operation and functions he needs on the Machine.
8.13.3 Non-󰄋op use
The Transmitting Unit indicates if it has been on for twenty-four hours non-󰘵op (the red LED
blinks and an acou󰘵ic signal sounds).
The Transmitting Unit automatically switches off after 3.5 minutes after the onset of the signal.
Bring the Machine to a safe 󰘵ate before the Transmitting Unit automatically switches off.