Instruction Manual

LIUPJMV03_eng-00 AUTEC
28
8.11 Command activation
When the Radio Remote Control is 󰘵arted, it is possible to activate movements, functions and
commands on the Machine by acting on the related joy󰘵icks, switches or pushbuttons, whose
functions and symbols are decided by the Manufacturer and/or the In󰘵aller.
To identify the relation between the actuators and the corresponding Machine movements, the
Machine Manufacturer and/or the In󰘵aller shall provide relevant in󰘵ructions and the User shall
be properly trained.
8.12 Interruption of the radio link
When the radio link is incorrect or interrupted for a certain period of time ("Passive Stop" indicated
in the Technical Data Sheet), the automatic 󰘵op function activates (see paragraph "Control
devices" in "Part A" of the Manual).
The green LED on the Transmitting Unit blinks fa󰘵.
The POWER LED on the Receiving Unit illuminates 󰘵eadily.
To 󰘵art the Radio Remote Control, press the START pushbutton and hold it down until the
green LED repeats one or two blinks and a pause. If the red LED illuminates, refer to chapter
11.
When the green LED repeats one of the following sequences: one or two blinks and a pause,
the Radio Remote Control is active and it can send commands and activate the Machine.
8.13 Transmitting Unit automatic switch o󰓐
Automatic switch off of the Transmitting Unit occurs in the following cases.
- When the battery is 󰘱at (see paragraph 8.13.1).
- When the Radio Remote Control is not used for a certain time (see paragraph 8.13.2).
- When the transmitting unit is powered and never switched o󰘯 for twenty-four hours non-󰘵op
(see paragraph 8.13.3).
The green LED on the Transmitting Unit switches off.
The POWER LED on the Receiving Unit illuminates 󰘵eadily.
To 󰘵art the Radio Remote Control, press the START pushbutton and hold it down until the
green LED repeats one or two blinks and a pause. If the red LED illuminates, refer to chapter
11.
When the green LED repeats one of the following sequences: one or two blinks and a pause,
the Radio Remote Control is active and it can send commands and activate the Machine.
8.13.1 Low battery
The Transmitting Unit indicates if the battery is not sufficiently charged (the red LED blinks and
an acou󰘵ic signal sounds).
The Transmitting Unit automatically switches off after 3.5 minutes after the onset of the signal.
It is necessary to bring the Machine to a safe 󰘵ate and replace the battery with a charged one
(see paragraph 8.7).