Instruction Manual
LIUPJMV03_eng-00AUTEC
41
Signals Possible reasons Solutions
At Radio Remote Control art
up, the green LED is on and the
red LED emits one long blink and
some short blinks.
At lea one of the actuators
corresponding to digital
commands D2-D20 is activated.
Bring the actuators to the re
position. If necessary, it is
possible to identify the activated
command looking up the table in
paragraph 11.2.
At Radio Remote Control art
up, the green LED is on and the
red LED emits two long blinks
and some short blinks.
At lea one of the actuators
corresponding to analogue
commands A1-A8 is activated.
At Radio Remote Control art
up, the green LED is on and the
red LED emits three long blinks
and some short blinks.
At lea one of the actuators
corresponding to direction
commands H1-H8 is activated.
At Radio Remote Control art
up, the green LED is on and the
red LED emits four long blinks
and some short blinks.
At lea one of the actuators
corresponding to direction
commands L1-L8 is activated.
Whenever the red LED illuminates, the acouic signal device activates.
At the end of each signal, the Transmitting Unit switches off.
To correctly view signals displayed at the Radio Remote Control art up, press the
START pushbutton and hold it pressed until the Transmitting Unit switches off.