Instruction Manual
LIUPJMV03_eng-00 AUTEC
32
5. Insert the power keyswitch in the Transmitting Unit (see paragraph 8.1).
6. In a Take & Release Radio Remote Control, activate the TAKE command and hold it active
until the Receiving Unit's seven-segment displays show the following signal: "---1" or "---2".
7. Press the START pushbutton and hold it down until the green LED repeats the sequence:
three blinks and a pause. If the red LED illuminates, refer to chapter 11.
When the green LED repeats the sequence: three blinks and a pause, the Radio Remote Control
is active and it can send commands and activate the Machine.
When working with the cable control, the radio link is cut off:
8.16 BACK-UP UNIT
If the Transmitting Unit cannot be used, it can be replaced with a Transmitting Unit called BACK-
UP UNIT; you need to ask for it from Autec.
It is identical to the Unit that cannot be used any more; the only difference is the presence of
the plate “BACK-UP UNIT” on the battery housing.
As required by andard IEC 60204-32, each Radio Remote Control is uniquely
identified through a serial number (S/N). Therefore, upon replacement of the
Unit, the serial number of the Transmitting Unit to be replaced mu be written
on the BACK-UP UNIT, so that all the Units belonging to the Radio Remote
Control show the same serial number.
Autec cannot be held responsible if the serial number of the Transmitting Unit
to be replaced has not been marked on BACK-UP UNIT.
9 Inructions for the User
The chapter "Instructions for the User" in "Part A" of the Instruction Manual contains the
warnings for the use that add to those provided in this chapter. Therefore, please refer to
that part of the Manual.
The following inructions are general, they refer to general usage situations for the Transmitting
Unit, and indicate how people should or should not behave when using the unit: these do not
cover any possible risk situation and/or drawback that may depend on specific applications of
Autec Radio Remote Controls.
However, inructions given in the following paragraphs do not replace nor complete the
inructions that mu be provided to the User by the Manufacturer of the Machine where an
Autec Radio Remote Control (to which the PJM Transmitting Unit belongs) is inalled.