Instruction Manual

LIUDPP002_eng-00 AUTEC

When carrying out maintenance on the Machine, always disconnect power

supply from the Receiving Unit. In the event of necessary maintenance on the

Machine (by way of example: welding), disconnect all the electrical connections

of the Receiving Unit.

9.2.1 Daily routine maintenance

Before 󰘵arting to work:

- Make sure that the symbols on panel on the Transmitting Unit and on the Receiving Unit are

clearly visible and replace the panel if necessary.

- Make sure that the plates on the Transmitting Unit and on the Receiving Unit are readable and

intact (refer to the speci󰘰c part in the Manual concerning the Transmitting Unit and the

Receiving Unit).

- Make sure that the mechanical operation of the GSS or EMS pushbutton is correct.

- Make sure that the Transmitting Unit and the Receiving Unit are undamaged in all their parts.

- Check the Receiving Unit 󰘵atus and remove any material from it (du󰘵, remnants, object, etc.):

never use solvents or 󰘱ammable/corrosive materials for cleaning, and do not use high-

pressure water cleaners or 󰘵eam cleaners.

- Check that the wiring of the Receiving Unit is intact and connected.

During normal operation:

- Do not damage the Transmitting Unit (avoid falls, bumps, contact with water, 󰘱uids or liquids,

etc.).

- Pay attention not to let materials (by way of example: concrete, sand, grease, dirt, lime, du󰘵,

etc.) deposit on the Transmitting Unit because they can compromise its use and safety.

After using the Radio Remote Control:

- Clean the Transmitting Unit: never use solvents or 󰘱ammable/corrosive materials and do not

use water jet cleaners, or air pressure or 󰘵eam pressure cleaners.

- Store the Transmitting Unit in clean and dry places.

9.2.2 Three-month routine maintenance

At lea󰘵 every three months:

- Check the correct correspondence between the commands that are sent and the manoeuvres

that are carried out by the Machine.

- Make sure that the SAFETY outputs (of UMFS function) only activate after the Radio Remote

Control has 󰘵arted, and when at lea󰘵 one movement command is sent to the Machine. Also

make sure that the SAFETY outputs disable when all the movement commands are released.

This is safety critical maintenance: it is necessary to keep a record (date, signature, comments)

showing that this check has been regularly carried out. Keep the record together with other

in󰘵allation documents.

- Make sure that all the outputs in the Receiving Unit operate correctly, and check that each

output activates when the corresponding operation is enabled and deactivates when the

operation is disabled.