Instruction Manual
LIUDPP002_eng-00AUTEC
55
Before any maintenance operation, disconnect the Receiving Unit from the
power supply, using the devices and inructions provided by the Machine
Manufacturer and by the Inaller.
After each maintenance operation, always make sure that all commands sent
by the Transmitting Unit activate only the corresponding expected operations.
In case of malfunction, switch off the Transmitting Unit and disconnect power
supply from the Receiving Unit: this way, the syem "Machine+Radio Remote
Control" is disabled; it mu not be used until the problem has been solved
by implementing the necessary technical operations.
After each maintenance operation, if a Unit has been opened, close it correctly,
in order to maintain the protection degree from du, contaminants and water:
- Make sure that the gasket is intact and correctly seated.
- Check that the housing parts correctly t so that they overlap.
- Tighten the screws.
9.2 Routine maintenance
Routine maintenance consis of operations needed to preserve the Radio Remote Control
normal usage conditions, thus implementing fine-tuning, checks, planned replacement actions
that necessarily arise from the normal use of the product.
All given inructions mu be followed correctly at each commissioning, that is:
- Whenever the Radio Remote Control and/or the Machine is inalled or assembled
- Whenever the Machine location/position changes
- After special maintenance.
Routine maintenance carried out as described in this Manual is fundamental for using the Radio
Remote Control safely.
Special applications may require more specific routine maintenance actions to be carried out
at different periods (by way of example: if the working environment is particularly dirty, or
temperature is very high or very low (see limits provided in paragraph 8.3), or in case of heavy
application, or if it is used very frequently, some maintenance actions may be required more
frequently depending on the inructions provided by the Machine Manufacturer and/or by the
Inaller).