Instruction Manual

LIUDPP002_eng-00 AUTEC

7.2 Delay in command response time

Under normal conditions, the delay between the activation/deactivation of a

command in the Transmitting Unit and the activation/deactivation of the

corresponding output in the Receiving Unit requires the "Command response

time" indicated in the Technical Data (see paragraph 4.5). With poor radio link

(by way of example: EM interference, exceeded working range) this delay may

protract up to the "Cut in time of the automatic 󰄋op function (ATS)" indicated

in the Technical Data (see paragraph 4.5). As for the SAFETY outputs only,

the "UMFS cut-in time" (see technical data in "Part D" of the In󰄋ruction Manual)

adds up to this time.

The Manufacturer, the In󰄋aller, the Owner, the User and/or the Maintenance

Technician, mu󰄋 make sure that these delays never lead to a dangerous

situation in the specific uses.

7.3 Inadvertent activation of commands

The User shall operate with the Transmitting Unit in a correct manner, in accordance with the

in󰘵ructions for use and maintenance.

If the Unit is used correctly, accidental contact with the User's body parts or

with external bodies does not cause inadvertent activation of the actuators.

Any action carried out on the Transmitting Unit, or on part of it, aiming at

activating the actuators in a different way from the one indicated in the

in󰄋ructions for use con󰄋itutes an improper use of the Radio Remote Control.

The User mu󰄋 use the Radio Remote Control in conformity with the in󰄋ruction

for use and maintenance and with all the Laws, the Regulations and the

Standards, even local, in force in the country where the Radio Remote Control

and the Machine are used; moreover, the User mu󰄋 always have the control

of the Radio Remote Control and remain in the usage position, as described

in the relevant specific part concerning the Transmitting Unit.