Instruction Manual

LIUPJQ000_eng-00AUTEC
45
11.2 2.8” display
The table below li󰘵s malfunctions signalled by the 2.8” display, if present on the Transmitting
Unit, and the solution to those malfunctions.
If the problem persi󰘵s after attempting the sugge󰘵ed solution, contact the support service of
the Machine Manufacturer.
Signals Possible reasons Solutions
At Radio Remote Control 󰘵art
up,
the display shows the
description "Stop pressed 06 00".
The STOP pushbutton is
pressed.
Unlock the STOP pushbutton.
At Radio Remote Control 󰘵art
up,
the display shows the
description "Key fa Il 04 00".
The Transmitting Unit does not
work correctly.
Contact the support service of
the Machine Manufacturer.
The display shows the
description "Battery fail 05 01".
The battery is very low.
It is necessary to replace the
battery with a charged one (see
paragraph 8.7).
At Radio Remote Control 󰘵art
up, the display shows the
description "Safety active 07 00".
The SAFETY command is
activated (see Technical Data
Sheet).
Bring the actuators to the re󰘵
position.
At Radio Remote Control 󰘵art
up, the display shows one of the
following descriptions: "Digital
active", "Analog active", "Direct H
active" or "Direct L active".
At lea󰘵 one of the actuators
corresponding to commands
D2-D20, A1-A8, H1-H8 and
L1-L8 is activated.
Bring the actuators to the re󰘵
position. If necessary, it is
possible to identify the activated
command looking up the table in
paragraph 11.3.