Instruction Manual

LIUPJQ000_eng-00 AUTEC
44
Signals Possible reasons Solutions
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED makes THREE long
blinks.
The battery is very low.
It is necessary to replace the
battery with a charged one (see
paragraph 8.7).
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED makes FOUR long
blinks.
The SAFETY command is
activated (see Technical Data
Sheet).
Bring the actuators to the re󰘵
position.
At Radio Remote Control 󰘵art
up, the green LED is on and the
red LED makes ONE to FOUR
long blinks and some short
blinks.
At lea󰘵 one of the actuators
corresponding to commands
D2-D20, A1-A8, H1-H8 and
L1-L8 is activated.
Bring the actuators to the re󰘵
position. If necessary, it is
possible to identify the activated
command looking up the table in
paragraph 11.3.
Whenever the red LED illuminates, the acou󰘵ic signal device activates.
The Transmitting Unit switches off 3.5 minutes after the red LED has been blinking
fa󰘵.
To correctly view signals displayed at the Radio Remote Control 󰘵art up, press the
START pushbutton and hold it pressed until the Transmitting Unit switches off.