Instruction Manual

LIUPJQ000_eng-00 AUTEC
30
8.14 Switching o󰓐 the Transmitting Unit
Switch off the Transmitting Unit when not actively using the Radio Remote
Control to operate the Machine, or when work is otherwise interrupted, even
for short periods. Do not leave the load hanging or the Machine in dangerous
conditions (even when charging the Unit or changing the battery).
FAILURE TO DO SO CAN RESULT IN SERIOUS BODILY INJURY OR DEATH
AND/OR PROPERTY DAMAGE.
Voluntary switch off of the Transmitting Unit occurs in the following cases.
- when the power keyswitch is turned anti-clockwise or removed.
- When the battery is removed (see paragraph 8.7.2).
- When the STOP pushbutton is pressed.
8.15 Data Feedback Function
The User receives information and/or signals concerning some specific situations and the
movements of the controlled Machine by means of the Data Feedback function.
The Data Feedback function acts through the LED array and/or the display.
Any information shown and signalled on the display and/or through the "Data
Feedback" LEDs can never be considered or used as a safety signal or for
legal metrology.
When operating and moving the Machine, remember that the Radio Remote
Control does not operate autonomously when potential hazardous situations
are displayed and signalled.
During normal Radio Remote Control operation, pay particular attention to the indications
displayed and signalled by the display and/or through the LEDs: they can be helpful to evaluate
the Machine working 󰘵atus.
8.15.1 Operation with display
If the Transmitting Unit has a display, it is possible to show warning icons, the measurements
collected from the Machine and their description.
The Machine Manufacturer chooses which information are displayed and the way they are
displayed (icons and/or measurements and/or descriptions).
The battery level and the quality of the radio link are also always indicated.