Instruction Manual

LIUPJQ000_eng-00 AUTEC
28
8.9 How to take control of the Receiving Unit in a Take & Release Radio
Remote Control
To take control of the Receiving Unit, activate the TAKE command and hold it active until in the
Receiving Unit's seven-segment display appears "---1" or "---2".
8.10 How to release the Receiving Unit in a Take & Release Radio Remote
Control
To release the Receiving Unit, activate the RELEASE command. Depending on the Transmitting
Unit's configuration, this command may be associated with one or two actuators.
If the RELEASE command is associated to one actuator, to release the Receiving Unit you need
to activate the actuator and hold it active until in the Receiving Unit's seven-segment display
appears "---F".
If the RELEASE command is associated to two actuators, to release the Receiving Unit you
need to activate the two actuators simultaneously and hold them active until in the Receiving
Unit's seven-segment display appears "---F".
Autec can set the RELEASE command to be activated in a different way than
the above mentioned ones, only upon reque󰄋 by either the Machine
Manufacturer or the In󰄋aller: the User mu󰄋 be properly trained in the matter.
By releasing the Receiving Unit of a Take & Release Radio Remote Control,
the User gives an explicit consent to the other Users, thus enabling them to
take control of the Receiving Unit ju󰄋 released.
8.11 Command activation
When the Radio Remote Control is 󰘵arted, it is possible to activate movements, functions and
commands on the Machine by acting on the related joy󰘵icks, switches or pushbuttons, whose
functions and symbols are decided by the Manufacturer and/or the In󰘵aller.
To identify the relation between the actuators and the corresponding Machine movements, the
Machine Manufacturer and/or the In󰘵aller shall provide relevant in󰘵ructions and the User shall
be properly trained.
8.12 Radio link interruption
When the radio link is incorrect or interrupted for a certain time lapse ("Passive Stop" indicated
in the Technical Data Sheet), the automatic 󰘵op function activates (see paragraph "Control
devices" in "Part A" of the Manual).
The green LED on the Transmitting Unit blinks fa󰘵.
The POWER LED on the Receiving Unit illuminates 󰘵eadily.
To 󰘵art the Radio Remote Control, press the START pushbutton and hold it down until the
green LED repeats one or two blinks and a pause. If the red LED illuminates, refer to chapter
11.