Instruction Manual

LIUPJQ000_eng-00AUTEC
23
8.5 Command meaning
Commands on the Unit are specified according to the Machine's operations and functions.
Their presence and functions are decided and defined by the Machine Manufacturer, who
chooses the symbol conventions too.
The control devices described below, when present, perform the following functions (usually
the symbol conventions are as in the images).
8.5.1 RPM+/- switch (during normal operation)
This switch increases (rpm +) or decreases (rpm -) the number of
revolutions of a Machine's engine.
Symbol Meaning
This symbol identifies the command that increases the number of revolutions of a
Machine's engine.
This symbol identifies the command that decreases the number of revolutions of a
Machine's engine.
8.5.2 TEACH switch (during REMOTE SETUP)
This switch is used to:
- Set maximum and minimum values of proportional outputs (see
"Part D" in the In󰘵ruction Manual).
- Set values related to the re󰘵 position of proportional outputs (o󰘯set)
(see "Part D" in the In󰘵ruction Manual).
- Invert the movement direction of the joy󰘵ick's axis (see the
In󰘵allation Manual).
Symbol Meaning
This symbol identifies the TEACH+ command.
This symbol identifies the TEACH- command.