Instruction Manual

LIUPJQ001_eng-00AUTEC
39
11.2 2.8” display
The table below li󰘵s malfunctions signalled by the 2.8” display, if present on the Transmitting
Unit, and the solution to those malfunctions.
If the problem persi󰘵s after attempting the sugge󰘵ed solution, contact the support service of
the Machine Manufacturer.
Signals Possible reasons Solutions
At Radio Remote Control 󰘵art
up,
the display shows "Stop pressed
06 00".
The STOP pushbutton is
pressed.
Unlock the STOP pushbutton.
At Radio Remote Control 󰘵art
up, the display shows "Key fa Il
04 00".
The Transmitting Unit does not
work correctly.
Contact the support service of
the Machine Manufacturer.
The display shows "Battery fail
05 01".
The battery is very low.
It is necessary to replace the
battery with a charged one (see
paragraph 8.7).
At Radio Remote Control 󰘵art
up, the display shows "Safety
active 07 00".
The SAFETY command is
activated (see Technical Data
Sheet).
Bring the actuators to the re󰘵
position.
At Radio Remote Control 󰘵art
up, the display shows "Analog
active ".
At lea󰘵 one of the actuators
corresponding to analogue
commands A1-A8 is activated.
Bring the actuators to the re󰘵
position. If necessary, it is
possible to identify the activated
command looking up the table in
paragraph 11.3.
At Radio Remote Control 󰘵art
up, the display shows "Digital
active ".
At lea󰘵 one of the actuators
corresponding to digital
commands D2-D20 is activated.
At Radio Remote Control 󰘵art
up, the display shows "Direct H
active" (where "Direct" 󰘵ands for
"Direction").
At lea󰘵 one of the actuators
corresponding to direction
commands H1-H8 is activated.
At Radio Remote Control 󰘵art
up, the display shows "Direct L
active" (where "Direct" 󰘵ands for
"Direction").
At lea󰘵 one of the actuators
corresponding to direction
commands L1-L8 is activated.