Instruction Manual

LIUDP1002_eng-00AUTEC
13
3.2 FCC conformity
A Dynamic+P series' Radio Remote Control working in the 915-928MHz frequency band, whose
Units are li󰘵ed in the following table, complies with the requirements of the 󰘵andards FCC
(Federal Communication Commission) Part 15.
Unit FCC ID
PJB Transmitting Unit Model J8P Type NJ555 OQA-J8PNJ555
PJC Transmitting Unit Model J6P Type NJ355 OQA-J6PNJ355
PJM Transmitting Unit Model J8P Type NJ555 OQA-J8PNJ555
PJN Transmitting Unit Model J6P Type NJ355 OQA-J6PNJ355
PJQ Transmitting Unit Model J6P Type NJ355 OQA-J6PNJ355
PJQ Transmitting Unit Model J6P Type NJ255 OQA-J6PNJ255
PJR Transmitting Unit Model J8P Type NJ555 OQA-J8PNJ555
CRP Receiving Unit Model CRP Type NL055 OQA-CRPNL055
Place the antenna of the Receiving Unit in a position that ensures a minimum
separation di󰄋ance of 20cm from all the people that can be in the working
area.
Read carefully the section of the Manual where the antenna position is
described, both in the general part and in the specific part referring to the
Receiving Unit.
Autec allows you to use only the dedicated antenna supplied either with the remote
control or as original spare part. The use of any other type of antenna is prohibited
and will invalidate the warranty.