Instruction Manual
4 Frequencies
Dynamic series' Radio Remote Controls can work in the 915-928MHz frequency band.
The Radio Remote Controls' working frequency is dened by market-specic laws
and standards. In order for the system “Machine+Radio Remote Control” to be
compliant and therefore to be used, these laws and standards must be respected:
if they are not, the Radio Remote Control cannot and must not be used.
Autec cannot be held responsible if the Radio Remote Control is set with
frequencies that are forbidden in the country of use.
4.1 915-928MHz frequency band
4.1.1 Frequencies
The radio link between the Units of Autec Dynamic series Radio Remote Controls is established
at one of the frequencies permitted by the US, Canadian and Australian standards in force
when the system is put on the market.
Frequencies used ........................................................................................................ 256
RF power ........................................................................ meets FCC and IC requirements
Channel spacing ...................................................................................................... 50kHz
The Units communicate with one another in dynamic mode, that is:
- they use a working frequency in the 915-928MHz band,
- they check that the frequency is free before using it,
- they continually change the working frequency to maintain the radio link even when
interference occurs.
4.1.2 Countries of usage
Dynamic series' Radio Remote Controls working in the frequency band 915-928MHz can be
used in the US, Canadian and Australian markets.
Check on the technical data plate of the Units in which markets the Radio Remote Control
can be used.
AUTEC - Dynamic Series
Frequencies 15
LIUDY2003_eng-00