Instruction Manual

Unit FCC ID IC number
FJL Transmitting Unit
Model FJL Type NF022
OQA-FJLNF022 9061A-FJLNF022
FJM Transmitting Unit
Model FJM Type NF022
OQA-FJMNF022 9061A-FJMNF022
FJM Transmitting Unit
Model FJM Type NZ422
OQA-FJMNZ422 9061A-FJMNZ422
FJN Transmitting Unit
Model J2F Type NZ322
OQA-J2FNZ322 9061A-J2FNZ322
FJQ Transmitting Unit
Model J2F Type NZ322
OQA-J2FNZ322 9061A-J2FNZ322
FJR Transmitting Unit
Model FJR Type NF022
OQA-FJRNF022 9061A-FJRNF022
FJR Transmitting Unit
Model FJR Type NZ422
OQA-FJRNZ422 9061A-FJRNZ422
FJS Transmitting Unit
Model FJS Type NF022
OQA-FJSNF022 9061A-FJSNF022
PCR
OQA-PCRNKZ22
d
/
a. Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
b. This radio transmitter has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each antenna
type indicated. Antenna types not included in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited for use with this device.
Antenna type Antenna gain Antenna impedance
Autec stylus λ/4 <2dBi 50 Ohm
Autec stylus λ/4 with 5m
RG58
<2dBi 50 Ohm
Autec stylus λ/4 with 20m
RG213/U
<2dBi 50 Ohm
c. Autec allows you to use only the dedicated antenna supplied either with the remote control or
as original spare part. The use of any other type of antenna is prohibited and will invalidate the
warranty.
d. Place the antenna of the Receiving Unit in a position that ensures a minimum separation distance
of 20cm from all the people that can be in the working area.
AUTEC - Dynamic Series
Conformity 13
LIUDY2003_eng-00