Instruction Manual
11 Malfunction signalled by the Transmitting Unit
The table below lists malfunctions that are signalled by LEDs on the Transmitting Unit and
the solution to those malfunctions.
If the problem persists after attempting the suggested solution, contact the support service
of the Machine Manufacturer.
Light signals Possible reason Solutions
The green LED blinks
fast.
The red LED
a
blinks for
3.5 minutes.
The battery is not suciently
charged or the Transmitting
Unit has been on for eight
hours
b
.
The battery needs to be replaced
with a charged one (see paragraph
8.7) or you need to switch o the
Transmitting Unit and re-start the
Radio Remote Control.
The green LED blinks
slowly.
The red LED
a
blinks for
3.5 minutes.
The green LED is o.
The red LED
a
has ONE
very long blink.
The Transmitting Unit does not
work correctly.
Perform the address storage
procedure (see paragraph 8.16.1).
At Radio Remote
Control start up,
the green LED is o
and
the red LED
a
has ONE
long blink
b
.
The STOP pushbutton is
pressed.
Unlock the STOP pushbutton.
At Radio Remote
Control start up,
the green LED is o
and
the red LED
a
has TWO
long blinks
b
.
At least one of the actuators
corresponding to commands
D2-D20 and SAFETY is
activated.
Bring the actuators to the rest
position.
At Radio Remote
Control start up,
the green LED is o
and
the red LED
a
has
THREE long blinks
b
.
The battery is very low.
The battery needs to be replaced
with a charged one (see paragraph
8.7).
40
LIUFJC000_eng-00
Malfunction signalled by the Transmitting Unit
AUTEC - Dynamic Series