Instruction Manual

8.10 Command activation
When the Radio Remote Control is started, it is possible to activate movements, functions
and commands on the Machine by acting on the related joysticks, switches or pushbuttons,
whose functions and symbols are decided by the Manufacturer and/or the Installer. To
identify the relation between the actuators and the corresponding Machine movements, the
Machine Manufacturer and/or the Installer shall provide relevant instructions and the User
shall be properly trained.
8.11 Radio link interruption
When the radio link is incorrect or interrupted for a certain time lapse ("Passive Stop" indicated
in the Technical Data Sheet), the automatic stop function activates (see paragraph "Control
devices" in "Part A" of the Manual).
The green LED on the Transmitting Unit switches from blinking slowly to fast.
The POWER LED on the Receiving Unit switches from blinking to steady on.
To start the Radio Remote Control, press the START pushbutton and hold it down until the
green LED blinks slowly. If the red LED lights up, refer to chapter 11.
When the green LED illuminates and blinks slowly, the Radio Remote Control is active and
it can send commands and activate the Machine.
Please note that when the START pushbutton is pressed to start up the Radio
Remote Control after the radio link had been interrupted, commands that
were enabled before the interruption, and the resulting Machine's functions,
are immediately activated. If the reactivation of such Machine's functions can
lead to a dangerous situation, the user must perform the following procedure:
1. press the STOP pushbutton (so that all the functions enabled before
the stop are cancelled),
2. unlock the STOP pushbutton,
3. press the START pushbutton.
8.12 Transmitting Unit automatic switch o󰓐
The Transmitting Unit automatically switches o󰘯 when:
- the battery is 󰘱at (see paragraph 8.12.1),
- the Radio Remote Control is not used for a certain time (see paragraph 8.12.2),
- the Transmitting Unit is powered and never switched o󰘯 for eight hours non-stop (see
paragraph 8.12.3).
The green LED on the Transmitting Unit switches o󰘯.
The POWER LED on the Receiving Unit switches from blinking to steady on.
To start the Radio Remote Control, press the START pushbutton and hold it down until the
green LED blinks slowly. If the red LED lights up, refer to chapter 11.
When the green LED illuminates and blinks slowly, the Radio Remote Control is active and
it can send commands and activate the Machine.
26
LIUFJC000_eng-00
General operating instructions
AUTEC - Dynamic Series