Instruction Manual

8.7.2 Battery removal

Push the battery towards the contacts on the Transmitting Unit (3) and remove it from the

housing (4).

When the Transmitting Unit is not in use, remove the battery if possible.

8.8 ID internal tx memory

The "ID internal tx memory" is a key containing the address that is used to code messages

exchanged between the Transmitting Unit and the Receiving Unit.

This key, if present, is inside the Transmitting Unit.

The Transmitting Unit has an "ID internal tx memory" if the Unit has a "M-Key", and not the

"Key ID 0-1", as its power keyswitch (see paragraph 8.1).

8.9 Starting up the Radio Remote Control

Starting up the Radio Remote Control consists in establishing a radio link between the

Transmitting Unit and the Receiving Unit.

The Radio Remote Control start up is protected by a power keyswitch to

prevent unauthorised use of the Machine.

To activate the Radio Remote Control it is necessary to insert the power

keyswitch as described in the following procedure.

Perform the following procedure to start the Radio Remote Control:

1. power on the Receiving Unit respecting the voltage limits provided in the technical data

(see "Part D" of the Manual). The POWER LED switches on,

2. Insert a charged battery in the Transmitting Unit (see paragraph 8.7.1),

3. insert the power keyswitch in the Transmitting Unit (see paragraph 8.1),

4. press the START pushbutton and hold it down until the green LED blinks slowly. If the

red LED lights up, refer to chapter 11.

When the green LED illuminates and blinks slowly, the Radio Remote Control is active and

it can send commands and activate the Machine.

LIUFJC000_eng-00

General operating instructions

AUTEC - Dynamic Series