Instruction Manual

8 General operating instructions
8.1 Power keyswitch
The Transmitting Unit have a power keyswitch. It can either be:
- M-Key (see paragraph 8.1.1).
- Key ID 0-1 (see paragraph 8.1.2).
The Radio Remote Control cannot work if the power keyswitch is not inserted in the Transmitting
Unit.
8.1.1 M-Key
The M-Key allows to power the Transmitting Unit.
||key_ID_bis| insertion|
Press the M-Key inside the corresponding housing until it hits the bottom.
M-Key removal
Pull the M-Key by its string to remove it from its housing.
8.1.2 Key ID 0-1
The Key ID 0-1 allows to power the Transmitting Unit.
It stores the Radio Remote Control's address. Therefore, the Key
ID 0-1 can only be used in the Transmitting Unit of the Radio
Remote Control to which it belongs.
As the Radio Remote Control's address is stored in the Key ID
0-1, this must be used with very strict care.
Only use the Key ID 0-1 for the Transmitting Unit with which it was provided.
Key ID 0-1 insertion
Perform the following operations to insert the Key ID 0-1:
1. insert the Key ID 0-1 into the corresponding housing,
2. rotate the Key ID 0-1 clockwise.
Key ID 0-1 removal
Perform the following operations to remove the Key ID 0-1:
3. rotate the Key ID 0-1 anticlockwise,
4. pull the Key ID 0-1 to remove it from its housing.
AUTEC - Dynamic Series
General operating instructions 17
LIUFJC000_eng-00