Instruction Manual

LIUDY2004_eng-00AUTEC
13
3 Conformity
Addressees of in󰘵ructions mu󰘵:
- Make sure that the Radio Remote Control works within the frequency band permitted in the
country where it is used.
- Make sure that the Radio Remote Control works correctly, in compliance with the applicable
󰘵andards in the relevant country.
- Not modify the Radio Remote Control conformity, by performing modi󰘰cations or technical
operations that change its operation.
During training on or usage of Autec Radio Remote Controls, local provisions imposing the
conservation of product conformity with local 󰘵andards mu󰘵 be respected, as well as specific
󰘵andards related to safety in the use of Radio Remote Controls or electrical devices, both in
the working environment or outside of it.
3.1 FCC conformity
A Dynamic series' Radio Remote Control working in the 915-928MHz frequency band, whose
Units are li󰘵ed in the following table, complies with the requirements of the 󰘵andards FCC
(Federal Communication Commission) Part 15.
Unit FCC ID
ADD Receiving Unit Model ADD Type NE022 OQA-ADDNE022
ARM Receiving Unit Model ARM Type NC022 OQA-ARMNC022
ARM Receiving Unit Model ARM Type NB022 OQA-ARMNB022
ARS Receiving Unit Model ARS Type ND022 OQA-ARSND022
ARX Receiving Unit Model ARX Type NG022 OQA-ARXNG022
CRS Receiving Unit Model CRS Type NA022 OQA-CRSNA022
CRX Receiving Unit Model CRX Type NH022 OQA-CRXNH022
FJB Transmitting Unit Model FJB Type NZ422 OQA-FJBNZ422
FJC Transmitting Unit Model J2F Type NZ322 OQA-J2FNZ322
FJL Transmitting Unit Model FJL Type NF022 OQA-FJLNF022
FJM Transmitting Unit Model FJM Type NF022 OQA-FJMNF022
FJM Transmitting Unit Model FJM Type NZ422 OQA-FJMNZ422
FJN Transmitting Unit Model J2F Type NZ322 OQA-J2FNZ322
FJQ Transmitting Unit Model J2F Type NZ322 OQA-J2FNZ322
FJQ Transmitting Unit Model J2F Type NZ222 OQA-J2FNZ222
FJR Transmitting Unit Model FJR Type NF022 OQA-FJRNF022
FJR Transmitting Unit Model FJR Type NZ422 OQA-FJRNZ422
FJS Transmitting Unit Model FJS Type NF022 OQA-FJSNF022
PCR - OQA-PCRNKZ22