Instruction Manual

LIUFJQ001_eng-00 AUTEC
18
Removing the mechanical key
Do the following to remove the mechanical key:
1. Turn the mechanical key anticlockwise.
2. Pull the mechanical key to remove it from its receptacle.
8.1.2 Key ID 0-1
The Key ID 0-1 makes it possible to power the Transmitting Unit.
It 󰘵ores the Radio Remote Control's address.
Therefore, the Key ID 0-1 can only be used in the Transmitting Unit of
the Radio Remote Control to which it belongs.
As the Radio Remote Control's address is 󰘵ored in the Key ID 0-1, this
mu󰘵 be used with very 󰘵rict care.
Only use the Key ID 0-1 for the Transmitting Unit with which it was provided.
8.1.3 Inserting the Key ID 0-1
To insert the Key ID 0-1, do as follows:
1. Insert the Key ID 0-1 in its housing.
2. Turn the Key ID 0-1 clockwise.
8.1.4 Removing the Key ID 0-1
To remove the Key ID 0-1, do as follows:
1. Turn the Key ID 0-1 anti-clockwise.
2. Pull the Key ID 0-1 to remove it from its housing.
8.2 START pushbutton
The START pushbutton is used to:
- 󰘵art the Radio Remote Control (see paragraph 8.9)
- activate the horn when the Radio Remote Control is 󰘵arted.